beautypg.com

Code 3 Volt User Manual

Installation instructions v series hide-a-leds

background image

920-0211-00 Rev. A

Page 1 of 3

IMPORTANT!

Read all instructions before installing and using. Installer: This manual must be delivered to the end user.

Do not install and/or operate this safety product unless you have read and understand the safety

information contained in this manual.

1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are

essential to ensure the safety of you and those you are trying to protect.

2. Exercise caution when working with live electrical connections.

3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high

current arcing, which can cause personal injury and/or severe vehicle damage, including fire.

4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output

performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can

operate the system without losing eye contact with the roadway.

5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the

vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks

or compartment doors), people, vehicles, or other obstructions.

6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.

Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an

intersection, driving against traffic, responding at a high rate of speed, walking on or around traffic lanes.

7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying

all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and

regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.

WARNING!

Failure to install or use this product according to manufacturer’s recommendations may result in property damage, serious

bodily/personal injury, and/or death to you and those you are seeking to protect!

!

Installation Instructions

V Series Hide-A-LEDs

Size:

0.87H x Dia. 1.51

Input Voltage:

12/24 VDC

Current Draw:

0.7A Max

Operating temperature range: -30 to +50ºC
Lumens:

VA(Amber) 200

VB(Blue)

100

VR(Red)

200

VW(White)

460

Contents:

Specifications:

1 X HIDE-A-LED head with built-in power module and cable
1 X Mounting Gasket
2 X #6 X 1/2” Screws
1 X Bezel

Installation & Mounting:

Important! This unit is a safety device, and it must be connected to its own separate, fused power point to assure its continued operation

should any other electrical accessory fail.

Before installation, examine the LED heads for transit damage. Do not use damaged or broken parts.

The V Series Hide-A-LED™provides exceptional warning capability

in a compact light that can be either mounted inside a head/tail light

casing or surface mounted using the included bezel. Using 6 high

intensity LEDs the V Series features 12 or 24 VDC operation, 16

flash patterns, the ability to synchronize with additional units and a

9’ cable.

This manual is related to the following products: