Code 3 Twist and Lock Hide-A-Blast - Manual (Page 6)

FLASH PATTERN SELECTION
FLASH MODE
Any one of the 20 Flash Patterns may be selected by using the blue wire to scroll through the pat-
terns. Touch the blue wire to ground for about 1 second and then remove it. The flash pattern will
switch to the next pattern. When the yellow wires (SYNC) from each light are connected, lights
with Phase 1 patterns selected will flash in an alternating sequence with lights that have a Phase 2
pattern selected. The following patterns are available.
Description
1. signal alert alternating (Factory Default)
2. signal alert simultaneous phase1
3. signal alert simultaneous phase2
4. rapid flash alternating
5. rapid flash simultaneous phase1
6. rapid flash simultaneous phase2
7. single flash 75 alternating
8. single flash 75 simultaneous phase1
9. single flash 75 simultaneous phase2
10. single flash 375 alternating
11. single flash 375 simultaneous phase1
12. single flash 375 simultaneous phase2
13. action flash alternating
14. action flash simultaneous
15. modul flash alternating
16. modul flash simultaneous
17. action scan
18. STEADY
19. Cycle Flash
20. off
6
1. Connect the Power/Control wire harness assembly to a switch. To select one of the 30 different flash func-
tions, turn the light on and touch the bare end of the blue wire to ground for about one second. You can also
scroll backward through the flash pattern table (see the PATTERN SELECTION TIMING section for complete
details. Repeat this process until you reach the desired flash pattern. After you have selected the desired
flash pattern, you should cover the bare end of the blue wire with heat shrinkable tubing to prevent an ac-