Code 3 Twist and Lock Hide-A-Blast - Manual (Page 4)

1. First, carefully plan the installation so that the HB Series LED Lights will not interfere with the mounting or
operation of the vehicle's existing light fixtures. Using a 1 inch hole saw, cut a hole in the vehicle's light fixture
in a location that will allow the HB Series LED light to be mounted in such a way that it will provide maximum
light inside the reflector (see Figure B). Use a deburring tool to remove burrs and to chamfer the edge of the
hole before inserting the HB6PAK. Proper installation will provide an excellent seal and prevent water from
entering the light fixture.
Wiring
1. Install the LED light heads in the desired locations.
2. Route the cables between the light heads and the control switch panel. Make sure the cable is secure along
the chosen routing inside the vehicle to prevent damage by chafing or binding. Be sure to keep the cables away
from engine hot spots.
3. Secure the cables and the HB Series flasher module using plastic wire ties.
4
Installation and Mounting
The HB Series LED Light components are water resistant but NOT waterproof and should
be located in an area protected from the weather and water.
!
WARNING!
FIGURE A