Code 3 SuperVisor_3Up_OPTIX_2011_Ford_F150 User Manual

Page 4

Caution: Drilling into the housing of the light bar could damage wiring or other internal

components.

FIgURE

Installation and Mounting Instructions: Cont.

wiring Instructions

Finish routing the cable as desired. It is advisable to leave an extra loop of cable when installing the light bar to allow for future

changes or reinstallations. Connect the black lead to a solid frame ground (earth), preferably the (-) or ground (earth) side of the

battery, and the power wire to the +12V terminal of the battery. Connect the remaining wires as shown on page 5.

This unit must be mounted within the interior passenger compartment of the vehicle only. It is not intended for

use in exterior applications. All devices should be mounted in accordance with the manufacturer’s instructions

and securely fastened to vehicle elements of sufficient strength to withstand the forces applied to the device.

Driver and/or passenger air bags (SRS) will affect the way equipment should be mounted. This device should

be mounted by permanent installation and within the zones specified by the vehicle manufacturer, if any. Any

device mounted in the deployment area of an air bag will damage or reduce the effectiveness of the air bag and

may damage or dislodge the device. Installer must be sure that this device, its mounting hardware and electri-

cal supply wiring does not interfere with the air bag or the SRS wiring or sensors. Mounting the unit inside

the vehicle by a method other than permanent installation is not recommended as unit may become dislodged

during swerving, sudden braking or collision. Failure to follow instructions can result in personal injury.

wARNINg: