Code 3 SuperVisor with TriCore for Dodge Charger - Manual (Page 4)

4
The bracket fasteners make excellent hard mounting points for radar guns and video cam-
eras etc. Caution: Drilling into the housing of the light bar could damage wiring or other
internal components.
FIgURE 6 FIgURE 7 FIgURE 8
Step 5 Mounting the SuperVisor
®
Outer Mounting Brackets
Once the two outer brackets are attached and the cable is routed, the SuperVisor is ready to be installed. With the SuperVisor held in po-
sition behind the outer mounting brackets (see Figure 6) line up the mounting holes in the outer mounting brackets with the threaded holes
in the SuperVisor and thread the supplied 1/4"-20 bolts and internal tooth lock washers into the SuperVisor's Outer Panel (see Figure 7).
Tighten the two 1/4-20 bolts making sure the bolts are all the way at the top of the slot in the outer mounting brackets (see Figure 8).
Step 6 Mounting the SuperVisor Inner Mounting Brackets
Place the inner brackets on the retaining clips as shown in Figures 9 and 10. Attach the inner brackets and retaining clips to the
headliner as illustrated in Figure 11. Do not fully tighten the screws at this time. Next line up the mounting holes in the Inner mounting
brackets with the threaded holes in the SuperVisor and loosely thread the supplied 1/4"-20 bolts in the SuperVisor's Outer Panel (see
Figure 12). Tighten the three Torx screws in each of the two outer Pivot Brackets (see Figure 13). Tighten the two center inner mount-
ing screws (see Figure 11 again). Then while pushing up on the SuperVisor's Outer Panel, tighten the last two 1/4-20 bolts at the Inner
Mounting Brackets (see Figure 14).
FIgURE 9 FIgURE 10 FIgURE 11
FIgURE 12 FIgURE 13 FIgURE 14
wiring Instructions
It is advisable to leave an extra loop of cable when installing the light bar to allow for future changes or reinstallations.
Connect the black lead to a solid frame ground (earth), preferably the (-) or ground (earth) side of the battery, and the
power wire to the +12V terminal of the battery. Connect the remaining wires as shown on page 5.