Code 3 PSE440 Remote Strobe Power Supply - Manual (Page 7)

Flash Control Switching Options
To select any one of eight different FLASH MODES , simply connect the White, Orange, Yellow and Brown
wires to a switch , or switches , in the combinations indicated in Table 1. NOTE: THE BROWN WIRE WILL PUT
THE PSE440 IN
Cycle Flash TM MODE WHEN CONNECTED TO (+ Vdc). THIS WILL OVERRIDE ANY OTHER
FLASH MODE SELECTED.
In the following table a “1“ = 12/24 Vdc and a “0 “ = Ground ( Earth ) or no connection.
BROWN YELLOW ORANGE WHITE FLASH MODE
0 0 0 0 ALL HEADS OFF
0 0 0 1 QUAD FLASH HEADS 1 AND 4
0 0 1 0 QUAD FLASH HEADS 2 AND 3
0 0 1 1 QUAD FLASH ALL HEADS
0 1 0 1 STANDARD DOUBLE FLASH ALL HEADS
1 X X X IN Cycle Flash TM ALL HEADS
TABLE 1 - FLASH MODE SELECTION
Switching Control Variations
The Model PSE440 strobe outlet flashing sequence variations are controlled by four factors:
1. Selecting one or more of the Flash Modes available, see Table 1.
2. Determining the user supplied switching necessary to control these modes.
3. Choosing to connect the remote strobe light head assemblies to the alternating or simultaneous
strobe light flashing functions on the power supply outlets. See Figure 6, page 8.
4. Number of remote strobe light head assemblies used in the system.
7