Warranty, Product returns – Code 3 PSE440 Remote Strobe Power Supply User Manual

Page 12

Code 3, Inc.

10986 N. Warson Road

St. Louis, Missouri 63114-2029—USA

www.code3pse.com

Problems or Questions? Call our Technical Assistance HOTLINE - (314) 996-2800

Revision 2, 12/2005 - Instruction Book Part No. 3693

Code 3 is a registered trademark of Code 3, Inc. a subsidiary of Public Safety Equipment, Inc.

WARRANTY

This product was tested and found to be operational at the time of manufacture.

Provided this product is installed and operated in accordance with the manufacturer's recom-
mendations, Code 3, Inc. guarantees all parts and components except the lamps for a period
of 2 years from the date of purchase or delivery, whichever is later. Units demonstrated to be
defective within the warranty period will be repaired or replaced at the factory service center
at no cost.

Use of a lamp or other electrical load of a wattage higher than installed or recom-

mended by the factory, or use of inappropriate or inadequate wiring or circuit protection
causes this warranty to become void. Failure or destruction of the product resulting from
abuse or unusual use and/or accidents is not covered by this warranty.

Code 3 shall in no way be liable for other damages including consequential, indirect or

special damages whether loss is due to negligence or breach of warranty.

CODE 3 MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING,

WITHOUT LIMITATION, WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH
RESPECT TO THIS PRODUCT.

PRODUCT RETURNS

In order to provide you with faster service, if you are going to return a product for repair

or replacement*, please contact our factory to obtain a Return Goods Authorization Number
(RGA number) before you ship the product to Code 3. Write the RGA number clearly on the
package near the mailing label. Be sure you use sufficient packing materials to avoid
damage to the product being returned while in transit.

*Code 3 reserves the right to repair or replace product at its discretion and assumes no responsibility or

liability for expenses incurred for the removal and/or reinstallation of products requiring service and/or repair.