Code 3 MC SuperVisor Ford PI Sedan - Manual (Page 5)

5 4
Larger wires and tight connections will provide longer service life for components. For high current wires it
is highly recommended that terminal blocks or soldered connections be used with shrink tubing to protect
the connections. Do not use insulation displacement connectors (e.g. 3M ® Scotchlock type connectors).
Route wiring using grommets and sealant when passing through compartment walls. Minimize the
number of splices to reduce voltage drop. High ambient temperatures (e.g. under hood) will significantly
reduce the current carrying capacity of wires, fuses, and circuit breakers. Use "SXL" type wire in engine
compartment. All wiring should conform to the minimum wire size and other recommendations of the
manufacturer and be protected from moving parts and hot surfaces. Looms, grommets, cable ties, and
similar installation hardware should be used to anchor and protect all wiring. Fuses or circuit breakers
should be located as close to the power takeoff points as possible and properly sized to protect the wiring
and devices. Particular attention should be paid to the location and method of making electrical connections
and splices to protect these points from corrosion and loss of conductivity. Ground terminations should
only be made to substantial chassis components, preferably directly to the vehicle battery. The user should
install a fuse sized to approximately 125% of the maximum Amp capacity in the supply line to protect
against short circuits. For example, a 30 Amp fuse should carry a maximum of 24 Amps. DO NOT USE
1/4" DIAMETER GLASS FUSES AS THEY ARE NOT SUITABLE FOR CONTINUOUS DUTY IN SIZES
ABOVE 15 AMPS. Circuit breakers are very sensitive to high temperatures and will "false trip" when
mounted in hot environments or operated close to their capacity.
WARNINg!
LIGHT BLUE/WHITE
PRIMARY
PURPLE
PRIMARY
RED
PRIMARY
PASSENGER SIDE 2011 PI SEDAN DRIVER SIDE
RED/WHITE
PRIMARY
BROWN
PRIMARY
GREEN
PRIMARY
LIGHT BLUE
SECONDARY
WHITE
SECONDARY
ORANGE
SECONDARY
BROWN/WHITE
SECONDARY
PINK
SECONDARY
GREEN/WHITE
SECONDARY
MULTI COLOR SUPERVISOR INTERNAL WIRING DIAGRAM
NOTE: THIS IS THE LOCATION
FOR THE CALIFORNIA
STEADY BURN RED
LIGHT HEAD