Code 3 MC SuperVisor Ford PI Sedan - Manual (Page 4)

4
Caution: Drilling into the housing of the light bar could damage wiring or other internal components.
FIgURE 10 FIgURE 11 FIgURE 12
FIgURE 13 FIgURE 14 FIgURE 15
FIgURE 7-DRIVER SIDE SHOWN FIgURE 8 FIgURE 9
Installation and Mounting Instructions: Cont.
WARNINg: This unit must be mounted within the interior passenger compartment of the vehicle only. It is not intended
for use in exterior applications. All devices should be mounted in accordance with the manufacturer’s instructions
and securely fastened to vehicle elements of sufficient strength to withstand the forces applied to the device.
Driver and/or passenger air bags (SRS) will affect the way equipment should be mounted. This device should be
mounted by permanent installation and within the zones specified by the vehicle manufacturer, if any. Any device
mounted in the deployment area of an air bag will damage or reduce the effectiveness of the air bag and may damage
or dislodge the device. Installer must be sure that this device, its mounting hardware and electrical supply wiring does
not interfere with the air bag or the SRS wiring or sensors. Mounting the unit inside the vehicle by a method other
than permanent installation is not recommended as unit may become dislodged during swerving, sudden braking or
collision. Failure to follow instructions can result in personal injury.
Wiring Instructions
Finish routing the cable as desired. It is advisable to leave an extra loop of cable when installing the light bar to allow for
future changes or reinstallations. For wiring of the Multi Color SuperVisor, see pages 5 & 6.
LED Fusing Considerations
NOTE: The Components of the Multi Color SuperVisor System are circuit protected by the Multi Color SuperVisor System CC
Board so the individual wires in the System do not require fusing.
DO NOT APPLY 12 VOLTS DIRECTLY TO THE SUPERVISOR WIRES AFTER IT IS CONNECTED TO THE
SUPERVISOR MULTI COLOR CC BOX. THE MULTI COLOR SUPERVISOR CC BOARD OR THE LIgHT
HEADS COULD BE DAMAgED BY APPLYINg 12 VOLTS TO THE CC OUTPUTS!. WARNINg!