Code 3 MC SuperVisor Caprice - Manual (Page 11)

11
Notes:
Troubleshooting
All SuperVisor-MCs are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during
the life of the product, follow the guide below for information on repair and troubleshooting. Additional information may be obtained
from the factory technical help line at 314-996-2800. Follow the guide below for information on repair and troubleshooting.
TROUBLESHOOTING GUIDE
Note: LED modules must be replaced as a module. There are no user serviceable parts.
PROBLEM
LED module not
operating when
powered.
QUESTIONS POSSIBLE CAUSE
A. Bad power/ground
connection.
B. Defective module.
SOLUTION
A. Fix connection.
B. Replace module
N/A
This unit must be mounted within the interior passenger compartment of the vehicle only. It is not intended for
use in exterior applications. All devices should be mounted in accordance with the manufacturer’s instructions
and securely fastened to vehicle elements of sufficient strength to withstand the forces applied to the device.
Driver and/or passenger air bags (SRS) will affect the way equipment should be mounted. This device should
be mounted by permanent installation and within the zones specified by the vehicle manufacturer, if any. Any
device mounted in the deployment area of an air bag will damage or reduce the effectiveness of the air bag and
may damage or dislodge the device. Installer must be sure that this device, its mounting hardware and electri-
cal supply wiring does not interfere with the air bag or the SRS wiring or sensors. Mounting the unit inside
the vehicle by a method other than permanent installation is not recommended as unit may become dislodged
during swerving, sudden braking or collision. Failure to follow instructions can result in personal injury.
WARNINg: