Code 3 LP 6000 - Manual (Page 11)

11
Options & Specifications
Many options are available for the LP 6000. This section is designed to describe the function of, and mainte-
nance for, the various LP 6000 options.
STINGRAY - The StingRay is a modified rotating lamp which produces a patented three-mode signal that (1)
oscillates to the rear, (2) rotates conventionally, and (3) oscillates to the front. Lamp and reflector mainte-
nance is the same as for a typical rotating lamp.
ALLEY LIGHTS - Located at each end of the light bar, to provide light to the side of the vehicle. This smaller
unit is held in a metal bracket that is attached to the frame with 2 screws.
HIGH SPEED ROTATING LAMPS - A rotating lamp that produces twice as many flashes as a conventional
assembly. The only significant differences between this unit and a normal assembly are that a faster motor is
used. Maintenance is the same as for a typical rotating lamp.
STOP/TURN/TAIL LIGHTS - Located in the light bar facing rear, one on the driver side, one on the passen-
ger side, these lights provide stop, turn, and tail signals to following traffic when connected to the vehicle
lighting system. Bulbs used are an 1157 bayonet type.
D.O.T. LIGHTS - A set of three marker lights as required by the Department of Transportation for truck
application. Bulbs are wedge base "194" type.
FLASHER - The Table below shows the different models and their functions.
FLASHER TYPE
FEATURES 360RS 360RD 360RDK 700 710/711
100W (2 lights), X X
Alternating Flash
200W (4 lights), X X
Alternating flash
rear only or front
& rear
200W (4 lights), X
Alternating flash,
rear only, front &
rear, or steady burn
front/rear flash
200W Heavy duty X X
Alternating flash
200W Heavy duty X
Programmed flash
Parts Not Shown
50W Alley/Mini Takedown light module S35205M --
Center Lens Base Module S38130M --
L.P. Stingray Module S40009M --
L.P. Worklight