Code 3 CPS220 Remote Strobe Power Supply - Manual (Page 8)

Code 3 is a registered trademark of Public Safety Equipment, Inc.
CycleFlash is a trademark of Public Safety Equipment, Inc.
Public Safety Equipment (UK), Ltd. Public Safety Equipment, Inc.
Oldham Road, Rishworth 10986 N. Warson Road
Halifax, West Yorkshire—ENGLAND HX6 4QG St. Louis, Missouri 63114-2029—USA
Ph. 0422-824640 Fax 0422-824604 Ph. (314) 426-2700 Fax (314) 426-1337
Revision 1, 06/07 - Instruction Book Part No. T11480
©2007 Public Safety Equipment, Inc. Printed in USA
WARRANTY
This product was tested and found to be operational at the time of manufacture. Provided this
product is installed and operated in accordance with the manufacturer's recommendations, Public
Safety Equipment guarantees the CPS220 for a period of 3 years from the date of purchase or
delivery, whichever is later. Units demonstrated to be defective within the warranty period will be
repaired or replaced at the factory service center at no cost.
Use of a lamp or other electrical load of a wattage higher than installed or recommended by
the factory, or use of inappropriate or inadequate wiring or circuit protection causes this warranty to
become void. Failure or destruction of the product resulting from abuse or unusual use and/or
accidents is not covered by this warranty. Use of non-PSE components and assemblies may
cause damage to the system and/or personal injury, and voids all warranties on PSE systems and
components.
PSE shall in no way be liable for other damages including consequential, indirect or special
damages whether loss is due to negligence or breach of warranty.
PSE MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING, WITHOUT LIMITATION,
WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO THIS PRODUCT.
PRODUCT RETURNS
In order to provide you with faster service, if you are going to return a product for repair or
replacement*, please contact our factory to obtain a Return Goods Authorization Number (RGA
number) before you ship the product to PSE. Write the RGA number clearly on the package near
the mailing label. Be sure you use sufficient packing materials to avoid damage to the product
being returned while in transit.
*PSE reserves the right to repair or replace product at its discretion. PSE assumes no responsibility or
liability for expenses incurred for the removal and/or reinstallation of products requiring service and/or repair.
NEED HELP? Call our Technical Assistance Hotline - (314) 996-2800