Code 3 CPS220 Remote Strobe Power Supply - Manual (Page 2)

Introduction
The CPS220 Series Remote Strobe Power Supply represents the latest in state-of-the-art strobe warning
technology. The latest in MOSFET technology and advanced design provide efficient operation, meaning
superior performance, reliability and long life. The use of intelligent microprocessor control allows the Model
CPS220 series to offer more light pattern options and versatility than any other remote system available. The
user may select Quad, Triple, Double, Single, Active Flash or Variable Flash, Double-Double and Triple-Triple
Patterns. When connected to remote strobe heads, the CPS220 delivers the highest available level of
emergency warning signals.
Standard Features
The CPS220 Remote Strobe Power Supply is available as a 2 strobe Hide-a-way kit as part number
220HCL. The 220HCL comes complete with a CPS220 power supply, two Hide-a-way strobe tubes
and two 30' cables. Refer to CODE 3 manual T07715 for details on installation of the Hide-a-way
strobe tubes. All MODEL CPS220 Remote Strobe Power Supplies have the the following features:
12 AND 24 VDC OPERATION
REVERSE POLARITY PROTECTED
OUTPUT SHORT CIRCUIT/FLASHTUBE FAILURE PROTECTION
Power supply will shut down when trying to flash any heads that have been shorted.
MULTIPLE USER SELECTABLE FLASH PATTERNS
See Flash Control Options Section, page 6.
Note: A user supplied fuse (5A for 12VDC operation, 3A for 24V operation) must be installed in series
with the red wire. Install the fuse near the power source.
Specifications
OPERATING VOLTAGE: 10-30 VDC
POWER: 20 WATTS
ENERGY: 15 JOULES NOMINAL
STANDARD FLASH RATE: EACH STROBE LIGHT OUTLET 70 QUAD FLASHES/MIN.
ALTERNATING PAIR 140 QUAD FLASHES/MIN.
POWER CONSUMPTION: 3 AMPS AVERAGE @ 13.8 VDC