Code 3 Code 360 User Manual

Page 14

Strobe Lighthead

Assembly

Filter
(if supplied)

Electronics Module Removal

In the event that the power supply or a strobe lamp assembly must be returned to the factory for service, mark each wire with a tag
to identify each function and note the proper location before disconnecting the wiring. Figure 9 can be used to mark the locations of
the individual connections as well.

Refer to Figure 9 for power supply removal. Remove the four (4) screws holding the power supply. Disconnect the wire leads, and
move the power supply to the side. Remove the 2 screws holding the capacitor assembly and lift the strobe power supply/capacitor
assembly from the lightbar as a unit. To reinstall the power supply reverse the above steps.
Caution: Verify that wires are not pinched or damaged when reinstalling power supply.

FIGURE 8

FIGURE 10

FIGURE 9

MAXIMUM 27W

4-Head Power Supply

6-Head Power Supply

+12VDC
(Red)

Ground Wire
(Blk)

Control Wire Harness
(Yel/Blk,Brn/Blk)

Passenger's Side Front
(Org,Blk,Blk/Wht)

Driver's Side Front
(Brn,Blk,Blk/Wht)

Passenger's Side Rear
(Grn,Blk,Blk/Wht)

Driver's Side Rear
(Yel,Blk,Blk/Wht)

Rear Output
(Grn,Blk,Blk/Wht)

Rear Output
(Yel,Blk,Blk/Wht)

Rear Aux. Output
(Red,Blk,Blk/Wht)

Front Output
(Org,Blk,Blk/Wht)

Front Aux. Output
(Wht,Blk,Blk/Wht)

Front Output
(Brn,Blk,Blk/Wht)

5 N/C

FRONT

REAR

+12V(RED)

GND(BLK)

N/C(GREY)

FRONT(GRN)

REAR(BLUE)

RANDOM
FLASH
(YEL)

PSE 490E

FIGURE 10A