Code 3 930 and 940 Flashers - Manual (Page 6)

6
Testing the Flasher
Testing the 930 Flasher
1) Install the 20 amp. fuse in the in-line fuse holder.
2) Turn ON the switch connected to terminal 2. The Alley lights will flash (Wig/Wag) at 90
FPM.
3) Turn ON the switch connected to terminals 3. The Right Alley light will change to steady
burn mode.
4) Turn ON the switch connected to terminals 4. The Left Alley light will change to steady
burn mode.
If the flasher functions do not work according to the above description, recheck all of your connections.
Testing the 940 Flasher
Steps 1-4 above also apply to the 940 flasher. Complete steps 1-4 and then proceed to step 5
below.
5) Turn ON the switch connected to terminal 5. The Takedown lights will flash (Wig/Wag) at 90
FPM.
6) Turn ON the switch connected to terminals 8. The Takedown Lights will change to steady
burn mode.
If the flasher functions do not work according to the above description, recheck all of your connections.
NOTE: If you connected Terminal 1, the flasher will stop flashing when you turn on the low beams
headlights. If you want the flasher to continue to flash, DO NOT connect Terminal 1.