Code 3 40, 41, 42 Series Perimeter Lights - Manual (Page 4)

1. Select the desired mounting location for the strobe light head assembly.
2. Verify 2 inches minimum free clearance behind the mounting surface, see Figure 1.
3. Cut the opening and drill the holes, use Figure 2 template or the trim bezel if your light head is so equipped.
4. With one end of the cable at the light head mounting location, route the three wire cable to the Power
Supply.
5. At the light head end of the cable, insert the 3 AMP sockets into the AMP socket housing as shown in
Figure 3. Cut the shield wire flush with the jacket. (Strobe Lamp Assembly shown. Procedure is the same
for Halogen Lamp Assembly.)
6. Allow 3 inches minimum slack at the light head to facilitate lamp assembly replacement. Secure the cable.
7. At the power source end of the cable determine if the cable length is acceptable. If a shorter length is
required, coil the cable and tie with an electrical tie.
8. Insert the 3 AMP sockets into the AMP socket housing as shown in Figure 4.
9. Crimp the #8 ring terminal to the shield wire and attach to nearest grounded structure. (Strobe Model 40
Only.)
For 40, 41 or 42 series models with optional bezel snap the reflector into the bezel making sure the
reflector's "TOP" aligns with the bezel's 7023 product number. To insure proper sealing between the
bezel and the mounting surface, align the supplied bezel gasket with the details in the back of the bezel.
10. Test the lamp assembly (strobe or halogen) by connecting the reflector assembly to the cable and the
cable to the power source per the instructions with the power source.
11. Push the assembled AMP Mate-N-Lock connectors through the cut out in the vehicle.
12. Verify the '7021' product number on the reflector is on the top. Verify the "TOP" lens engraving is on the
top. Mount the reflector and lens by installing the four screws.
4
THIS END TO POWER
SUPPLY
FIGURE 4
SHIELD WIRE (Model 40 Only)
RED WIRE - HIGH VOLTAGE
(STROBE)
12/24 VDC(HALOGEN)
WHITE WIRE - TRIGGER(Model 40 only)
BLACK WIRE - GROUND (EARTH)
Light head must be mounted so that back side of reflector and bulb insertion area is enclosed
and shielded from weather.
WARNING!
!