Code 3 235H Remote Strobe Power Supply - Manual (Page 9)

INTERNAL FUSE REPLACEMENT
In the event that is determined the internal fuse needs to be replaced, the following procedure should be used
(See Figure 5):
1. Remove the light head cables and power harness from the power supply.
2. Remove the four #8 sheet metal mounting screws and power supply.
3. Remove the four 1/4" hex head screws holding the cover to the chassis.
4. Remove the cover from the chassis.
5. Replace the 7.5 AMP ATO style fuse.
6. Assemble the cover and chassis and re-install the power supply.
FIGURE 5
7.5 AMP ATO
style fuse
1/4" hex head
screws
Cover Chassis
9