Code 3 235H Remote Strobe Power Supply - Manual (Page 12)

Public Safety Equipment, Inc.
10986 N. Warson Road
St. Louis, Missouri 63114-2029—USA
www.code3pse.com
WARRANTY
This product was tested and found to be operational at the time of manufacture. Provided this
product is installed and operated in accordance with the manufacturer's recommendations, Public Safety
Equipment guarantees the 235H for a period of 1 year from the date of purchase or delivery, whichever
is later. Units demonstrated to be defective within the warranty period will be repaired or replaced at the
factory service center at no cost.
Use of a lamp or other electrical load of a wattage higher than installed or recommended by the
factory, or use of inappropriate or inadequate wiring or circuit protection causes this warranty to become
void. Failure or destruction of the product resulting from abuse or unusual use and/or accidents is not
covered by this warranty. Use of non-PSE components and assemblies may cause damage to the
system and/or personal injury, and voids all warranties on PSE systems and components.
PSE shall in no way be liable for other damages including consequential, indirect or special dam-
ages whether loss is due to negligence or breach of warranty.
PSE MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING, WITHOUT LIMITA-
TION, WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO THIS PRODUCT.
Revision 3, 11/2005 - Instruction Book Part No. T03596
©2005 Public Safety Equipment, Inc. Printed in USA
PSE Amber is a registered trademark of Public Safety Equipment, Inc.
PRODUCT RETURNS
If a product must be returned for repair or replacement*, please contact our factory to obtain a Return
Goods Authorization Number (RGA number) before you ship the product to Public Safety Equipment, Inc.
Write the RGA number clearly on the package near the mailing label. Be sure you use sufficient packing
materials to avoid damage to the product being returned while in transit.
*PSE reserves the right to repair or replace at its discretion. PSE assumes no responsibility or liability for expenses incurred for the removal and /or reinstallation
of products requiring service and/or repair; nor for the packaging, handling, and shipping: nor for the handling of products return to sender after the service has been
rendered.
PROBLEMS OR QUESTIONS? CALL OUR TECHNICAL ASSISTANCE HOTLINE (314) 996-2800