Code 3 235H Remote Strobe Power Supply - Manual (Page 7)

Switching Control Variations and Connections
The following diagrams show some of the wiring configurations possible for the various flash modes available
with the Model 235H strobe power supply. All fuses shown are to be customer supplied, and recommended
fuse ratings are to be observed. All switches are to be customer supplied.
VARIATIONS IN THE STANDARD DOUBLE FLASH MODE
ON-OFF SWITCHING HIGH POWER HIGH POWER-OFF-LOW POWER
VARIATIONS IN QUAD FLASH MODE
ON-OFF SWITCHING HIGH POWER HIGH POWER-OFF-LOW POWER
MULTIPLE FLASH MODES
By selecting the proper switching both flash modes can be used. This is an example of using one switch to
allow selection of either Double Flash mode or Quad Flash mode.
ON-OFF-ON SWITCHING HIGH POWER
NC
7.5A
+ To Power
Source
Power/Control
1 2 3 4
BLK (-)
NC
RED (+)
GRN (+)
7.5A
+ To Power
Source
DPDT
Center Off
BLK (-)
Power/Control
1 2 3 4
SPST
On-Off
7.5A
+ To Power
Source
NC
BLK (-)
SPST
On-Off
Power/Control
1 2 3 4
ORG (+) RED (+)
Power/Control
1 2 3 4
+ To Power
Source
DPDT
Center Off
GRN (+)
RED (+)
BLK (-)
7.5A
ORG (+)
BLK (-)
ORG (+)
RED (+)
7.5A
+ To Power
Source
DPDT
Center Off
Power/Control
1 2 3 4
NC
NC
RED (+)
7