Code 3 2004 LED Series Beacon - Manual (Page 6)

6
Notes
LED module housings may become hot with extended use. Allow modules
to cool completely before attempting to remove.
WARNING! !
TROUBLESHOOTING
Problem Probable Cause Remedy
Lighthead does not activate a. No power to unit a. Check wiring for loose connection.
b. Power input wire reversed b. Reverse Power wires.
c. Damaged or shorted cabling. c. Check cables for damage.
d. Defective Lighthead d. Replace lighthead module.
Lighthead is constantly ON a. Control wire permanently a. Avoid permanent grounding
grounded or shorted to GND. of control wire.
Maintenance:
The 2004 LED Beacons are completely sealed units designed to be maintenance free.
Refer to the guide below for help with troubleshooting. Should the unit be diagnosed as
malfunctioning, remove the unit and replace with a new module. No parts are accessible for
repair or replacement.