Code 3 2004 LED Series Beacon - Manual (Page 2)

2
The use of this or any warning device does not insure that all drivers can or will observe or
react to an emergency warning signal. Never take the right-of-way for granted. It is your
responsibility to be sure you can proceed safely before entering an intersection, driving
against traffic, responding at a high rate of speed, or walking on or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct mounting and
wiring. Read and follow the manufacturer’s instructions before installing or using this
device. The vehicle operator should insure daily that all features of the device operate
correctly. In use, the vehicle operator should insure the projection of the warning signal is
not blocked by vehicle components (i.e.: open trunks or compartment doors), people,
vehicles, or other obstructions.
This equipment is intended for use by authorized personnel only. It is the user’s responsi-
bility to understand and obey all laws regarding emergency warning devices. The user
should check all applicable city, state and federal laws and regulations.
Public Safety Equipment, Inc., assumes no liability for any loss resulting from the use of
this warning device.
Proper installation is vital to the performance of this warning device and the safe operation
of the emergency vehicle. It is important to recognize that the operator of the emergency
vehicle is under psychological and physiological stress caused by the emergency situation.
The warning device should be installed in such a manner as to: A) Not reduce the output
performance of the system, B) Place the controls within convenient reach of the operator
so that he can operate the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages and/or currents. Properly
protect and use caution around live electrical connections. Grounding or shorting of
electrical connections can cause high current arcing, which can cause personal injury and/
or severe vehicle damage, including fire. Incandescent lamps are extremely hot, allow to
cool completely before attempting to remove.
Any electronic device may create or be affected by electromagnetic interference. After
installation of any electronic device operate all equipment simultaneously to insure that
operation is free of interference. Never power emergency warning equipment from the
same circuit or share the same grounding circuit with radio communication equipment.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER
USE OF EMERGENCY WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY
OF EMERGENCY PERSONNEL AND THE PUBLIC.
WARNING!
!
Introduction
Installation & Mounting
Wiring Instructions
The 2004 LED Beacons are designed to operate on 12-48 Volt DC negative ground
(earth) systems.
1) Route the user's wiring from the unit into the engine or passenger compartment. Use
grommets and apply sealant if needed to keep water out. Use #18 GA. or larger
wires.
2) Connect the black lead from the unit to a solid frame ground (earth), or preferably the
negative terminal of the battery.
3) Connect the red lead from the unit to one side of the user supplied control switch.
4) Connect the other terminal of the switch through a fuse or circuit breaker to the
positive terminal(+) of the battery or to the stud on the battery side of the starter
solenoid or alternator. The fuse or breaker should be rated for 10 Amps. Be aware
that circuit breakers and fuses are heat sensitive devices. Mounting them in high
temperatures may cause "false tripping". Reversing the power connections will
activate the reverse polarity protection, resulting in no light output. To correct,
properly connect the red to (+) and the black to (-) earth.