Code 3 2004 LED Series Beacon - Manual (Page 4)

4
Pipe Mounting
The 2004 LED Beacon pipe mounting kit will accept a standard 1/2" NPT pipe flange
onto the beacon base. Four slotted holes are provided in the adapter plate to accomodate
the hole spacing of various pipe flanges. Attach the adapter plate to the pipe flange, then
to the beacon. Locknuts should be used to prevent the unit from working loose from the
mounting. Route the wiring as recommended and turn the beacon clockwise onto the pipe
by hand until secure. Do not over-tighten.
1) Rust Stains: Magnetic mounting is not intended as permanent mounting for beacons.
Long duration usage of any magnet will expose the high iron content of the steel, thereby
causing rust. The device should by removed when not used to prevent rust stains. Metallic
debris collected by the magnet will also contribute to rust stains. Insure that the magnet is
kept clean.
2) Surface rust stains can usually be removed with chrome polish, available at most auto
part stores.
3) As with any magnetically-mounted warning device, its use on the exterior of a moving
vehicle is at the sole discretion and responsibility of the user.
Magnetic mount products provide a secure, temporary installation in most circumstances
and is recommended for stationary use only. For maximum warning signal, mount the
beacon on the highest possible flat, level survace of the vehicle.
WARNING!
!
Figure 1