Catler DF 4010 - Manual (Page 9)

8
OPERATING YOUR DEEP FRYER DF 4010
OPERATING YOUR DEEP FRYER DF 4010
Before fi rst use
Remove all packaging materials and any
promotional labels from your deep fryer.
Wash the lid, removable bowl and wire frying
basket in hot soapy water and dry throughly.
Wipe inside of the bowl with a damp cloth
and dry thoroughly.
1. Place the deep fryer on a dry, level
surface. Ensure the deep fryer is not too
close to the edge of the bench top, and
that the power cord or basket handle
does not hang over the edge.
2. With the basket out of the deep fryer, add
oil to the bowl. Ensure not to add less
than the minimum level mark or exceed
the maximum level mark (3 litres).
Important: NEVER exceed the maximum fi ll
level (3 litres).
3. Replace the lid.
4. Plug the power cord into a 230 V power
outlet and turn on the power ´On´
switch.
5. Turn the temperature control dial to the
desired temperature. The red ´Power On´
light will illuminate.
Your Deep Fryer DF 4010 is fi tted with a special
interlock switch and will not operate if not
properly assembled.
6. Preheat the oil at the selected temperature
until the ´Green´ temperature ready light
illuminates.
When cooking the fi rst batch of food, allow the
deep fryer to cycle on and off twice (as indicated
by the green temperature ´Ready´ light) before
placing the food into the deep fryer. This will
take approximately 15–20 minutes.
NOTE
POWER CORD NEEDS TO BE FULLY EXTENDED BEFORE USE.
ALWAYS ADD THE REQUIRED AMOUNT OF OIL BEFORE SWITCHING THE
POWER ON AT THE POWER OUTLET.
NOTE
NOTE