Catler CP 8010 - Manual (Page 6)

4
CATLER RECOMMENDS SAFETY FIRST
We at Catler are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer foremost in mind.
In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions:
IMPORTANT SAFEGUARDS FOR YOUR CITRUS PRESS CP 8010
• Carefully read all instructions before
operating and save for future reference.
• Before use fully unwind the power cord.
• Always use the Citrus Press on a dry, level
surface.
• Remove any promotional stickers before
using the Citrus Press.
• Always make sure the Citrus Press is
properly assembled before connecting the
plug and switching on at the power outlet
and switching ON the On/Off button on the
appliance. The appliance will not operate
unless properly assembled.
• Always switch the appliance OFF at the
On/Off button, then switch off at the power
outlet and remove the plug if the appliance
is left unattended, if not in use, if moved or
dismantled for cleaning and when storing.
• Do not let the cord hang over the edge of
a table or counter, touch hot surfaces, or
become knotted.
• Do not place this appliance on or near a
hot gas or electric burner, or where it could
touch a heated oven.
• Do not leave the appliance unattended
when in use.
• Use caution when operating the appliance
– do not place hands or fi ngers near
moving or rotating parts.
• Avoid placing hands or fi ngers near Juicing
Press Arm mechanism at rear of Motor Base
when moving Juicing Press Arm into the
upright position.
• This appliance is not intended for use by
young children or infi rm persons without
supervision.
• Young children should be supervised
to ensure that they do not play with the
appliance.
• Do not immerse power cord or motor base
in water or any other liquid.
• This appliance is for household use only.
Do not use this appliance for anything
other than its intended use. Do not use
in moving vehicles or boats. Do not use
outdoors.
• The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.
• Any maintenance other than cleaning
should be performed at an authorised
Catler Service Centre.
• Strictly follow cleaning and care
instructions.
• Regularly inspect the supply cord, plug and
actual appliance for any damage. If found
damaged in anyway, immediately cease
use of the appliance and return the entire
appliance to the nearest authorised Catler
service centre for examination, replacement
or repair.
CATLER RECOMMENDS SAFETY FIRST