CASO Germany VC 300 Vacuum System - Manual (Page 46)

caso VC300 Pro 46
19 Troubleshooting
The following table may help you narrow down and address minor malfunctions:
19.1 Safety notices
WARNING
► Only qualified electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.
► Improperly performed repairs may result in personal injury or damage to the device.
19.2 Troubleshooting table
Fault Possible Cause To Rectify
Device does not turn
on Defective power cord Send device to Customer Service
A complete vacuum is
not being created in
the bag.
The open end of the bag is
not completely inside the
vacuum chamber
Position the bag correctly
The bag is defective Select another bag
There is residue on the
welding and the seal Clean the welding / seals and
retry once they are dry
The bag is not being
sealed correctly The sealing bar is
overheating so that the bag
melts Open the cover on the unit and
let it cool down for a few minutes.
Please use only specified bags
and rolls
Carefully follow all the steps in
Chapter Vacuuming and sealing.
Roll / bag is not positioned
correctly.
The bag does not hold
the vacuum after it has
been sealed
The bag is defective
Select another bag; wrap paper
around any sharp edges within
the bag.
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
Open the bag again and clean
the upper internal part of the bag.
Remove any foreign matter that
might be on the welding bar
before sealing.
PLEASE NOTE
► In the event of technical troubles, faulty devices or missing parts, please contact
Customer Service.