CASO Germany VC 300 Vacuum System - Manual (Page 37)

caso VC300 Pro 37
15.5 Disposal of the packaging
Caso believes in the importance of recycling and has selected packaging materials that
not only protect your unit from damage during transit, but can be recycled to minimize any
ecological impact.
Recycling the packaging materials preserves raw materials and reduces waste.
Take any packaging materials that are no longer required to a recycling collection
point for proper disposal.
PLEASE NOTE
► If possible, keep the original packaging for the duration of the guarantee period in the
event a return is necessary.
15.6 Setup
15.6.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfill the following prerequisites:
• The device must be set up on a solid, even, horizontal surface capable of supporting
the vacuum sealer and any items to be vacuum-sealed.
• Select a setup location where children cannot reach the hot sealing strip of the device.
• Do not set up the unit in a hot or damp environment or near flammable material.
• To operate correctly, the unit requires sufficient air flow. Leave at least 10 centimeters
(4 inches) of space on all sides when setting up the unit.
• Do not move the vacuum sealer when it is in operation.
• The electrical outlet must be easily accessible so that the plug can be quickly
disconnected in the case of an emergency.
• The setup of this unit in non-stationary locations (e.g., boats, airplanes, motor homes)
must be carried out by a qualified electrician, provided they guarantee the prerequisites
for the safe use of the unit.
15.7 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
• Before plugging in the unit, compare the voltage and frequency data on the vacuum
sealer’s rating plate (found on the bottom of the unit) with that of your electrical
network. This data must be compatible. If in doubt consult a qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The use of a multi-plug outlet adapter is not recommended due to fire danger.
• Inspect the power cord for damage and ensure it doesn’t run under the unit or over hot
or sharp surfaces.