beautypg.com

2 troubleshooting table, 18 disposal of the old device – CASO Germany VC 320 Vacuum Set User Manual

Page 50

background image

caso VC320 Pro

50

17.2 Troubleshooting table

Fault

Possible Cause

To Rectify

Device does not turn
on

Defective power cord

Send device to Customer Service

A complete vacuum is
not being created in
the bag.

The open end of the bag is
not completely inside the
vacuum chamber

Position the bag correctly

The bag is defective

Select another bag

There is residue on the
welding and the seal

Clean the welding / seals and
retry once they are dry

The bag is not being
sealed correctly

The sealing bar is
overheating so that the bag
melts

Open the cover on the unit and
let it cool down for a few minutes.
Please use only specified bags
and rolls

Carefully follow all the steps in
Chapter Vacuuming and sealing.

Roll / bag is not positioned
correctly.

The bag does not hold
the vacuum after it has
been sealed

The bag is defective

Select another bag; wrap paper
around any sharp edges within
the bag.

There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.

Open the bag again and clean
the upper internal part of the bag.
Remove any foreign matter that
might be on the welding bar
before sealing.

PLEASE NOTE

► In the event of technical troubles, faulty devices or missing parts, please contact

Customer Service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.

If these were put in the non-recyclable waste or were handled incorrectly, they could be
detrimental to human health and the environment. Therefore, do not put your old device
into the non-recyclable waste under any circumstances.

PLEASE NOTE

Please take your old unit to the nearest recycling center for safe disposal.

Until it can be disposed of properly, store your old unit away from children.