Salter Brecknell DS-1 - Manual (Page 4)

Page 4
Fig. 7
Fig.7: “M01” on the upper right corner of the display shows that there is one kind of
nutritional value saved in the scale.
Note: The memory is saved permanently, even if the scale is switched off or the battery
is removed.
Note: Repeating the above step 1)to step 3), you can add more nutritional values.
Note: The maximum number of food items that can be added to the memory is 99,
when the memory number on upper right corner of the LCD display reaches “99”,
it will begin to flash, it shows the memory must be cleared by following the
instruction in the “TO CLEAR MEMORY” section.
4. TO RECALL MEMORY
1) Press “MR” button to see the total calories of the food items stored to memory .
Take the above-mentioned data for example, the scale display as follows(Fig.8):
Fig.8
Fig.8:“Σ” means the scale is currently in “RECALL MEMORY” state. The “M01”
on the upper right corner of LCD means there is 1 kind of nutritional value has
been saved in the scale memory. (the maximum number of food items that can be
added to the memory is 99)
2) Press function buttons ”Kcal”, ”Kj”, ”Chol”, ”BE”, “Carb”, ”Fat”, “Prot” to
display the total nutritional values of the food items stored to memory.
3) The scale will return to simple weighing mode if not pressing any key in 5 seconds.
5. TO CLEAR MEMORY
To get an idea of how much nutritional values you have taken per day, you need to
clear the saved data before you weighing food.
Press “MC” button for 2 seconds to clear the saved data, the LCD display shows
“M00” on the upper right corner, 5 seconds later, the scale come into simple weighing
mode.