Salter Brecknell CS-200M - Manual (Page 3)

3
3. Remove the eight screws from the scale base using a phillips head screwdriver (as shown in the left
hand photo) and set screws aside in a safe place.
Figure 4. Remove Screws From Scale Base and Insert Pillar and Beam into Scale Base Assembly
Insert, but don’t fasten the pillar and beam into the scale base assembly as shown in Figure 4 (right
hand side photo).
Steelyard Rod Connection
The steelyard rod is located inside the pillar. Remove the wire tie(s) holding the steelyard rod
during shipment. Insert the pillar into the base. Once the pillar is inserted to the scale base, the
steelyard rod must be attached to the bottom of the scale. The two photos below show the hook of the
steelyard rod and an inside photo of the ring in the scale bottom. Latch the hook onto the D-shaped ring
shown in the right hand side picture.
Figure 5. Attach The Steelyard Rod To the Scale Base D-Ring
Fasten the eight screws once the pillar and beam is connected to the scale base and the steelyard rod is
hooked.
Figure 6. Insert and Tighten The Eight Screws
Steelyard rod (not
shown)
Steelyard rod
hook