Salter Brecknell PS500 - Manual (Page 12)

GND 5 --------------- 5 ------------------------ 5 --------------5 GND
DSR 4 --------------- 4 ------------------------- 4 --------------4 DTR
DTR 6 --------------- 6 ------------------------- 6 --------------6 DSR
CTS 7 --------------- 7 -------------------------- 7 --------------7 RTS
RTS 8 --------------- 8 -------------------------- 8 --------------8 CTS
NC 1 -------------- 1 -------------------------- 1 --------------1
NC 9 -------------- 9 -------------------------- 9 --------------9
Note: The indicator DB9 female’s pin4 and pin6 is shorted, pin7 and
pin8 is shorted!
2. When P4 is set to 7: the protocol of RS232 is compatible to with NCI-SP1, here
is the details:
2.1) The baud rate and data format is fixed as per P5 and P6 setting. Responses
to serial commands will be immediate, or within one weight measure cycle of the
scale. One second should be more than adequate for use as a time-out value by
remote (controlling) device.
2.2) The length of the weight field will be 7 digit weight data, one for minus sign,
one for decimal point, two for measure unit (e.g. “lb”, “kg”). If the unit is lb:oz,
another two for “lb” and one for a space () after lb. Units of measure
abbreviations are always lower case.
a) If the weight is overcapacity, the scale will return nine ‘^’ characters
(the field of minus sign, decimal point, weight data is filled by ‘^’).
If the weight is under capacity, it will return nine ‘_’ characters (the field of
minus sign, decimal point, and weight data is filled by ‘_’).
If the zero point is error, it will return nine ‘_’ characters.
b) The character will be ‘-’ for negative weight or a space character for positive
weight. Minus sign follows after the first digit.
c) Useless leading zero before digits is suppressed.
2.3) Key to symbols used
Line Feed character (hex 0AH)
Carriage Return character (hex 0DH)
19
End of Text character (hex 03)
Space (hex 20H)
H1H2H3 Three status bytes
Polarity character including minus sign for negative weight and a
space character for positive weight
W1-W7 weight data
decimal point
U1U2: measure units, kg, lb, or oz
2.4) Commands and response
(1) Command: W (57h 0dh)
Response:
① ^^^^^^^^^u1u2H1H2H3---over capacity
②________u1u2 H1H2H3 ---under capacity
③ ---------u1u2 H1H2H3---zero-point error
Note: If the weight unit is lb: oz, U1U2= oz in above item ①②③ .
④
w1w2w3w4w5w6w7u1u2H1H2H3
---Scale is stable, and the current weight unit is kg or lb. With or without decimal point
and the position is as per the P9 setting and current unit.
⑤
w1w2w3w4w5lbw6w7H1H2H3
Or
w1w2w3w4lb w5w6w7ozH1H2H3
----The current unit is lb: oz.
(2) Command: S (53h 0dh)
Response: H1H2H3
(3) Command: Z (5ah 0dh)
20