Salter Brecknell C3235 - Manual (Page 6)

6
You use the Configuration menu to set the following parameters:
rAngE Use this to set the Over/Accept/Under ranges.
Units Use this to set the unit of measure and to enter the count
mode.
A-OFF Use this to enable or disable the auto-off function. If enabled
the scale will power off automatically after 10 minutes of
inactivity.
FILt Use this to set the level of filtering.
Zero Use this to set the automatic zero tracking window.
bUZZEr Use this to enable or disable the beeper.
How to set each of these parameters is described below.
Accessing the Configuration Menu and Setting
Parameters
To access the Configuration menu, press and hold the F key for three
seconds…
rAnGE, the first menu item, is displayed.
rAnGE
Use this item to set the weight ranges which will trigger the Over/Accept/
Under annunciators.
1. Press and hold the F key for three seconds to access the
Configuration menu …
rAnGE is displayed.
2. Press the TARE key…
on or oFF is displayed.
3. Press the F key to toggle between the choices. To enable the range,
press the TARE key with on displayed. (Go to step
4 ) To disable the
range function, press the TARE key with oFF displayed. (Go to step
7 )
4. If you enabled the range function…