Vent, Rrangement, Reference – AVer FD1020 user manual User Manual
Page 68
62
Event > Arrangement > Preference
Record File:
File Format: IP camera allows 3 different types of recording file to change its record size. When
motion/alarm is triggered, there are 3 different types of record mode.
AVI File (With Record File Setting )
JPEG Files (With Record File Setting), only with MJPEG compression format.
Single JPEG (Single File with Interval Setting) (JPEG photo).
Pre Alarm and Post Alarm: Setups for video start and end time when motion detected, I/O, or
other devices got triggered.
[Note] Pre/Post Alarm record time is base on record time setting and IP camera built-in Ram
memory. Limited by IP camera built-in Ram Memory. When information is too much or video
quality set too high, it will cause recording frame drop or decrease on post alarm recording time.
Network Connected: When the network is down, it will save the video to local SD/SDHC card.
[Note]This function is only enabled in wire connection.
Network IP check: When the connection is down, it records the video to SD/SDHC card. Make
sure the video recording is continuous. To use this function, key in the IP address of the PC which
has recording software installed. E
nable the function of “Save to SD card”, then click “Apply”.