AVer FC1320-P&PW user manual - Manual (Page 45)

39
ENGLISH
System > Network Setting > IPv6>Wireless (FC1320-PW only)
Support 802.11 b/g/n
To set up the IP camera via wireless network, use Ethernet cable to connect the camera first. After you
finish the wireless setting and save it, remove the Ethernet cable.
[Note] The IP address is the same under both wireless and wired network. If the Ethernet cable is
plugged in the camera, the IP camera will use it to link to the Internet instead of wireless router.
Status of Wireless Networks: The camera scans and shows the SSID, Mode, Security, and
Signal Strength of wireless network here.
Wireless Setting
−
Mode: Infrastructure mode is used to link to the wireless router. Ad-hoc mode is used to link to
the PC directly. "Domain" and "Channel" options appear only in the Ad-hoc mode.
−
SSID: The ID of wireless network service. Please key in the SSID, which you want to link to.
−
Domain: The wireless network standards are different in each region. Please select as the
wireless system in your location. FCC is American standard. ETSI is European standard. JP is
Japan standard
−
Channel: Assign a channel for the camera in order to avoid interference
−
Security: Select WEP, WPA-PSK, or WPA2-PSK according to your wireless router setting