AVer SF1311H-C - Manual (Page 59)

55
Appendix C: PING IP Address
The PING (stands for Packet Internet Groper) command is used to detect whether a specific IP address is
accessible by sending a packet to the specific address
and waiting for a reply. It‟s also a very useful tool to
confirm Network Camera installed or if the IP address conflicts with any other devices over the network.
If you want to make sure the IP address of Network Camera, utilize the PING command as follows:
 Start a DOS window.
 Type ping x.x.x.x, where x.x.x.x is the IP address of the Network Camera.
The replies, as illustrated below, will provide an explanation to the problem.
If you want to detect any other devices conflicts with the IP address of Network Camera, also can utilize the
PING command but you must disconnect the Network Camera from the network first.