beautypg.com

AVer SF1311H-C User Manual

Page 28

background image

24

- Step 2: Enter the security key of WEP or WPA. Then click

Submit” button to activate wireless setting.

If user wants to configure wireless settings manually, please return to wireless page and follow the
steps as below:

MAC Address: Shows the MAC address of the WLAN card. (Only the administrator can change it.)

Interface Select: Choose wired or wireless mode.

Type:

Select the

Infrastructure

as the wireless mode. If your network is using a network connection

directly between the devices without wireless AP, and then, select the

Ad-Hoc

as the wireless mode.

SSID: the ID assigned to the wireless AP (Access Point). The camera system will auto-detect and display
the SSID of wireless AP.

Channel: Select the current wireless channel.

Security Mode: Support three kind of security modes:

-

None

-

WEP

-

WAP_PASK/WPA2_PSK

Obtain IP address automatically (DHCP): Checked the box if you want a DHCP Server to automatically
assign the camera an IP address.

IP Address, Subnet Mask, and Gateway: If you don

‟t want to use DHCP function, then you need to

enter these network parameters manually.


Click OK to save and enable the setting.


Note: To enable WLAN function, user must set these related parameters correctly at first. Then
power OFF the Camera and remove Ethernet cable from the Camera, and power ON the device
again to enable the WLAN function.