AVer MOB1304-NET - Manual (Page 81)

75
8.1.1 To Setup Remote System Setting
Click OK to exit and save the setting and Cancel to exit without saving the setting. The setting
here applies to Remote DVR system only.
i
After changed the DVR system setting, refresh your web browser in order to apply the new setting to the
DVR system.
8.1.1.1 System Setup
(1)
(2)
(3)
(4)
(5)
(6)
(1) Video Out Setting
- Video Output: Select the Video output to configure the value of Resolution, Sharpness
and Color Enhance.
- Resolution: Select the video display resolution.
- Sharpness: Adjust the sharpness of display video.
- Color Enhance: Adjust the color enhancement of display video.
(2) DLS Setting
Mark Enable DLS check box to enable daylight saving. And then, select the Start and End Time
by click setting.
- Time Offset: Assign a time that it is for daylight saving time offset in your time zone. For
example: if the time zone is in U.S. Eastern, the time offset is 1 hour.
(3) MISC
- Time Sync.: Enable/disable Network Time Protocol to adjust the time of system from the
network time server.
- Time Zone: Select the time zone of DVR located.
- Sync Type: Select the ways of the network time synchronize.
- NTP Server: Enter the URL of the network time server.
- Time Format: Select the format of time and date for the DVR system.
- Disk Overwrite: Enable/disable replacing the earliest record when the hard disk space
runs out. By default, the HDD overwrite setting is enabled