AVer W30 user manual - Manual (Page 41)

36
ENGLISH
R R S S - - 2 2 3 3 2 2 G G e e t t C C o o m m m m a a n n d d T T a a b b l l e e
Send Format︰0x52 + 0x0A + 0x01 + Data[0] + 0x53 + CheckSum
Receive Format︰0x53 + 0x0C + 0x01 + ReData[0] + 0x53 + ReCheckSum
*1 ：ReCheckSum = 0x0C xor 0x01 xor ReData[0] xor 0x52
4 4 B B
Function Data[0]
CheckSum
Code
ReData[0]
Red Value 0x02 0x5A Value[ ? ~ ? ]
Blue Value 0x03 0x5B Value[ ? ~ ? ]
Power Status 0x04 0x5C 0 : OFF 1: ON
Lamp Status 0x05 0x5D 0 : OFF 1: ON
Display Status 0x06 0x5E
0: Camera Mode
1: Playback Mode
2: PC-1 Pass Through
Video Output Status 0x07 0x5F 0: VGA 1: TV
Freeze Status 0x08 0x50 0 : OFF 1: ON
Brightness Value 0x0A 0x52 Value[ ? ~ ? ]
Contrast Value 0x0B 0x53 Value[ ? ~ ? ]
LIGHT BOX Status 0x0C 0x54 0 : OFF 1: ON
T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
This section provides many useful tips on how to solve common problems while using the
W30.
There is no picture on the presentation screen.
1. Check all the connectors again as shown in this manual.
2. Check the on/off switch of the display output device.
3. Verify the setting of the display output device.
4. If you are presenting from a notebook or computer through the display output device, check the
cable connection from computer RGB (VGA) output to RGB IN of W30 base and make sure W30
is in PC Mode.
5. Press RECONNECT button to reestablish connection with the W30 camera and base, or bind the
W30 camera and the base again.
I have set up the W30 and checked all the connections as specified in the manual
but I cannot get a picture on the preferred presentation screen.
1. Once the power is connected the unit is set to standby mode. Press the POWER button to turn on.
2. If your display output device is on TV or any analog device, please switch the TV-RGB dip switch
to TV.
3. The W30 camera could be power off, the battery needs charging,
4. The wireless signal could be low. Move the W30 camera closer to the base.