Alumax L-522 - Manual (Page 19)

5
RETURN PANEL INSTALLATION
5d
8
8
12.1
12.3
16
5a.
5b.
5c.
5d.
Using a measuring tape, mark the center of
the threshold of the base.
Using the marking established in the
previous step, run a second line up the
wall. Use a level to ensure verticality of this
line.
Place the wall jamb (8) onto the wall while
ensuring that the wall jamb slotted holes
are centered to the center line. The side
with holes of the wall jamb should face the
interior of the shower .
Drill holes using a Ø1/8 ½ drill bit, through
the wall using the wall jamb slotted holes as
reference.
Insert a drop of silicone into each hole
made in the previous step. Insert a wall
plug (12.1) into each hole and from there
the wall jamb can be repositioned and
permanently fastened using self drilling
screws #8-1 1/4 (12.3).
5a
5b
5c
THIS INSTALLATION PROCEDURE APPLIES FOR
ALL RETURN PANELS INSTALLATION
REGARDLESS QUANTITY OR ADITTIONAL
FIXTURE AS TOWEL BAR.
INSTRUCTION MANUAL
INTERIOR
SHOWER SIDE
511X, 512X, 521X, 522X, 521TBX, 522TBX