Alumax M-DP93X - Manual (Page 8)

8
INSTRUCTION MANUAL
DETERMINE HINGES LOCATION.
1
1A. Determine on which side the hinges will be mounted.
1B. Trace the hinge locations by referring to the "x" dimension on
page 7. Run it up the wall.
1C. Place the wall jamb (#2) on the threshold by centering the slotted
holes with the centerline.
1D. Mark the drilling locations at the top and bottom of the wall jamb.
Drill a hole at each location with a 1/4” drill bit.
INTERIOR
SHOWER SIDE
RIGHT CONFIGURATION LEFT CONFIGURATION
1A
1B
1C
2
1D
USE THE WALL JAMB (#2) AS TEMPLATE
TO MARK DRILLING LOCATIONS FOR
WALL-MOUNTED HINGES.
WALL-MOUNTED HINGES MUST BE SUPPORTED
AND FASTENED INTO A STUD FRAMING.
RIGHT CONFIGURATION SHOWN
x
y