Alumax M-DP93X - Manual (Page 3)

3
INSTRUCTION MANUAL
● Table of Contents
MODEL NUMBER ............................................... 2
GENERAL INSTRUCTIONS .................................... 3
INSTALLATION OVER CERAMIC TILES ....................... 3
NOTICE ......................................................... 3
CARE FOR YOUR FRAMELESS SHOWER DOOR ............. 3
PARTS LISTING ................................................. 4
PROVIDED HARDWARE ........................................ 5
REQUIRED TOOLS AND MATERIALS ......................... 5
CHART A........................................................ 6
CHART B ....................................................... 7
1. DETERMINE HINGES LOCATION. ......................... 8
2. FASTEN THE HINGES TO THE WALL. .................... 9
3. PREASSEMBLE THE DOOR. ................................ 9
4. INSTALL THE DOOR PANEL. .............................. 10
5. INSTALL THE DOOR HANDLE. ........................... 10
6. INSTALL THE DOOR GASKETS. .......................... 11
7. MOUNT THE WALL JAMB. ............................... 12
8. POSITION THE RETURN PANEL. ......................... 13
9. POSITION THE FIXED PANEL. ............................ 13
10. ADJUST THE GLASS PANELS. ........................... 14
11. FASTEN THE BOTTOM GLASS CLIPS. .................. 15
12. FASTEN THE RETURN PANEL. .......................... 15
13. FASTEN THE PIVOT SUPPORT BAR. ................... 16
14. SILICONE SEAL THE SHOWER. ......................... 17
● General Instructions
- Read this manual carefully and completely before
proceeding.
- It is recommended that you wear safety glasses at all
times during the installation.
● Installation over Ceramic Tiles
- Silicone should be used to seal the gap where the
- If your shower door is to be installed over ceramic tiles,
the tiles should lay completely under the wall jamb.
● Notice
- Caulking: no sealant is required inside the shower.
- All models are equipped with transparent sealing
gaskets.
● Care for your Frameless Shower Door
- Never use scouring powder pads or sharp instruments on
metal pieces or glass panels.
An occasional wiping down with a mild soap diluted
in water is all that is needed to keep the panels and
aluminum parts looking new.
- We recommend wiping the glass panels with a squeegee
after each use.