Alumax P-DR2W-48-60-CRP - Manual (Page 8)

8
3 CONTINUED
3D
Mark the glass clips for bottom of xed panel (6)
locations on the base, ensuring that the leading
edge of the return panel is tangent to the center of
threshold of the base. Draw a line marking the po-
sition of the front of the threshold (10) in relation to
the return panel based on dimension B. Proceed
to removing the return panel assembly (15)
(16b.c) as well as the glass clips (6).
Slide the return panel assembly (15) (16b.c) into
the wall jamb (16a) so as to allow the return panel
(16b), along with the clips for bottom of xed panel
(6), to rest on the threshold of the base.
3E
Apply a bead of silicone to the underside of the
threshold before proceeding to the next step.
3F
3G
Secure glass clips for bottom of xed panel on the
base, against the threshold (10) at the markings
established in step 3E. Secure these with #6-1
self-drilling screws (21) before repositioning the
gaskets. Reposition the return panel assembly
(15) (16b.c) as established in step 3D.
CENTER OF THRESHOLD*
3G
3F
3D
3E
16b
10
S
10
6
19
16a
6
6
10
16b
15
1/8˝
(3mm)
B
16a
15