Alumax 338 User Manual

Page 9

EPH-N00-06007

10-21-04

Page 8 of 8

Press the four rail end caps [AA] into the ends

of the top and bottom door rails.

NOTE: Do not use a metal hammer to install the end
caps.

Neatly caulk the inside perimeter of the shower

curb and the pivot and strike jambs.

NOTE: The caulking should be allowed to cure for
twenty-four hours before using your new shower enclo-
sure.

The Care and Cleaning of your new Alumax Bath Enclosure. The simplest and preferred

method of cleaning your unit is by washing it with clean water and drying with a soft cloth.
If soil is still present after drying, a non-abrasive cleanser with a pH of seven to eight may be
used. Comet Bathroom Cleaner

has been tested and is recommended by the Bath Enclosure

Manufacturers Association (BEMA). Do not use scouring pads, sharp instruments, or acid-
based cleansers to clean the unit.

Thank you for choosing an Alumax Bath Enclosure. Please take a moment to complete

and return the enclosed Customer Response Card. The information you provide helps us
improve the quality of our products and provide better service to you, our customer.

RAIL

END CAP

TOP PIVOT

BRACKET

PIVOT

JAMB

TOP

RAIL

DOOR

PANEL