Alumax 300d User Manual

Page 8

G03711142

12-21-05

Page 8 of 9

Determine the desired handing of the deflector [P].

The deflector leg must go to the inside of the unit as
shown in the drawing at right. To determine the door
panel width measure the distance from the edge of the
hinge rail to the far edge of the glass door panel. The
deflector should be cut to Door Panel Width - 1/4". Press
the deflector firmly on the bottom edge of the glass as
shown.

Neatly caulk the inside perimeter of the shower

curb and the wall jambs.

NOTE: Improper caulking will result in leaks.

NOTE: The caulking should be allowed to cure for twenty-
four hours before using your new shower enclosure.

Locate the handle [K] that has no Set Screws.

Place a Plastic Bushing [M] in the top handle hole then
place a Plastic Washer [L] against the glass. Place the
handle without Set Screws against the Plastic Washer
and insert the threaded end of the Cone Head Screw [N]
through the bushing into the threaded insert in the end of
the handle and tighten. Repeat the procedure for the
bottom hole. Place Plastic Washers [L] against the
opposite side of the glass and press the remaining handle
[K] over the end of the Cone Head Screw. While
holding the handles firmly against the glass tighten the
Set Screws [O].