Alumax 300d - Manual (Page 7)

Page 7 of 9 G03711142
12-21-05
Slide the strike jamb [G] over the remaining mounted
wall jambs [C] with the magnet facing outward. The
distance from the edge of the door panel glass to the face
of the strike jamb should be 1/4". Plumb the strike jamb
vertically and mark the location on the wall jamb.
11
Inside the shower enclosure, drill two 1/8" holes
thru the strike jamb [G] and into the wall jamb [C] 3/8"
to 3/4" from the wall and approximately 1" vertically from
each end of the strike jamb. Drill a third hole centered
between the first two, then enlarge the three outer holes
with a 3/16" drill for clearance on the self-tapping screws.
Attach the strike jamb permanently with three #6 x 3/8"
pan head screws [F].
10
Slide the latch [J] with magnet onto the strike edge
of the door panel. Close the door and slide the latch up
or down until the two magnetic strips are aligned. Use a
pencil or masking tape to mark the location of the latch
on the door. Position the strike jamb [G] so that the
magnet in the strike aligns with the magnet on the door
panel and the strike vinyl is snug against the edge of the
door panel glass.
Wrap the latch vinyl [H] over the edge of the door glass
between the marks and carefully drive the door latch
onto the door panel. Spraying glass cleaner or water
onto the vinyl will make assembly easier.
Close the door and check for proper operation of the
magnetic catch.
1/8"
12
EXTERIOR