Alumax 300d - Manual (Page 4)

G03711142
12-21-05
Page 4 of 9
1
The Alumax 300D Continous Hinge Shower
Door is completely reversible and may be installed
hinge-left or hinge-right. Refer to the illustration to
determine the correct position for your installation.
For maximum waterproofing, the hinge jamb should
always be opposite the shower head. These
instructions depict a hinge-left installation.
CAUTION: For safety, the door must always open
outward.
NOTE: The 300D unit may be installed without
using the sloped curb [A] provided. Its use is definitely
recommended for positive water control on shower sills
with little or no slope.
Measure the wall-to-wall opening at the shower sill and
cut the curb to the exact length. File the ends of curb as
necessary to fit the corner contours of the enclosure.
Place the curb on the shower sill with the raised portion
to the exterior of the enclosure. Make sure the curb is
centered on the sill and lightly mark its position on the sill
with a pencil.
Remove the curb from the sill and run two beads of caulk
inside the penciled marks on the shower sill. Place the
curb in the exact position marked and seat it firmly in the
caulking.
2
HINGE LEFT HINGE RIGHT
3
Slide one hinge [Q] into the slot on each end of the
strike jamb [G] as shown.