Alumax 300c User Manual
Page 9
EPH-N00-06086
6-3-02
Page 8 of 8
The Care and Cleaning of your new Alumax Bath Enclosure. The simplest and
preferred method of cleaning your unit is by washing it with clean water and drying with
a soft cloth. If soil is still present after drying, a non-abrasive cleanser with a pH of seven
to eight may be used. Comet Bathroom Cleaner
®
has been tested and is recommended
by the Bath Enclosure Manufacturers Association (BEMA). Do not use scouring pads,
sharp instruments, or acid-based cleansers to clean the unit.
Thank you for choosing an Alumax Bath Enclosure. Please take a moment to
complete and return the enclosed Customer Response Card. The information you
provide helps us improve the quality of our products and provide better service to you,
our customer.
Press the rail end cap [S] into the strike end of
the bottom rail [C].
NOTE: Do not use a metal hammer to install the
end cap.
13
Neatly caulk the inside perimeter of the shower
curb and the hinge and strike jambs.
NOTE: Improper caulking will result in leaks.
NOTE: The caulking should be allowed to cure for
twenty-four hours before using your new shower
enclosure.
14