Alumax 300c - Manual (Page 7)

EPH-N00-06086
6-3-02
Page 6 of 8
7
9
Slide the door pull handle [J] with magnet onto
the strike edge of the door panel. Close the door and
slide the handle up or down until the two magnetic
strips are aligned. Use a pencil or masking tape to
mark the location of the handle on the door.
Slip the door handle vinyl [K] onto the door between
the marks and carefully drive the door handle onto the
door panel. Spraying glass cleaner or water onto the
vinyl will make assembly easier.
Close the door and check for proper operation of the
magnetic catch.
8
Inside the shower enclosure, drill two 1/8" holes
thru the hinge jamb and into the wall jamb [D] 3/8" to
3/4" from the wall and approximately 1" vertically
from each end of the hinge jamb. Drill a third hole
centered between the first two, then enlarge the three
outer holes with a 3/16" drill for clearance on the self-
tapping screws. Attach the door panel assembly
permanently with three #6 x 3/8" pan head screws
[G].
Slide the hinge jamb of the door panel assembly
[B] over the mounted wall jamb [D] so the door will
open outward.
Adjust the door panel assembly so there is 1/4" clearance
between the strike jamb and the strike edge of the glass
door panel in the closed position. Mark the location
of the hinge jamb on the wall jamb with a pencil.
µ
'Е