Alumax 300c - Manual (Page 8)

Page 7 of 8 EPH-N00-06086
6-3-02
10
Adjust the drip vinyl [N] by sliding it left or
right until it just touches the curb. Trim the vinyl
flush with the hinge side and notch 1/2" longer than
the drip rail [L] as shown on the strike side. Slide the
vinyl into the drip rail and secure it on the hinge side
of the drip rail with one #6 x 3/8" truss head screw [P].
The drip plug [R] is supplied with a left and right hand
plug together. Break the two pieces apart and insert
the appropriate plug into the high (strike) side of the
drip rail. Discard the unused drip plug. Peel off the
tape backing [M] and carefully press the drip rail to the
door in the marked position.
11
12
Trim the flap on the clear vinyl strike jamb
seal to clear the bottom door rail.
Cut the drip rail [L] to the length of the
bottom rail plus 1 1/4". Clean the inside edge of the
bottom door rail and the flat side of the drip rail
thoroughly to ensure proper adhesion of the double
stick tape [M]. Unroll the tape and carefully attach it
to the back of the drip rail (do not peel the tape backing
yet). Insert the tapered drip vinyl [N] into the drip rail.
Position the drip rail flush with the bottom of the door
panel, 1/16" from the hinge jamb, then raise the strike
side until the bottom edge of the drip vinyl is parallel
to the curb [A]. Mark the location of each end of the
drip rail with a pencil.
NOTE: Cleaners with alcohol content can dissolve
the adhesive that attaches the drip rail. To prevent
this possibility, place a small bead of clear sealant at
the top of the drip rail where it is attached to the
bottom rail.