With other cameras, On position, With the nikon fa, fe2, and fg – Nikon Autofocus Speedlight SB-22 User Manual

Page 45: Off position, On position off position

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

With other cameras:
Though the ON position is normally recommended for
turning on the flash unit, STBY can also be used.
With other Nikon cameras, even if the camera’s expo

sure meter stays on, the SB-22 automatically turns off

when not used for one or two minutes. To turn on
again, set power switch to ON or OFF position, then

reset to STBY, For convenience, you may also push

the open-flash button to turn on the SB-22,

ON Position

With cameras other than the Nikon F-501fN2020,

F-401/N4004, F-301/N2000, FA, FE2 and FG:

This position is normally used to turn on the SB-22,

With the Nikon FA, FE2, and FG:

To turn on the SB-22 when using mechanical shutter
settings (M250, M90 or B), set power switch to ON,

OFF Position

When not using the flash unit, always set the power

switch to OFF position.