E press the shutter, A check battery power – Nikon FM2 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^ Pull out the film advance
lever (D to unlock the
shutter release button (D.
The film advance lever doubles as a
shutter release button lock. You can un
lock the shutter release button by simply
pulling out the film advance lever slightly
from the flush to the standoff position.
e Press the shutter
release button lightly to
switch the exposure meter
on.
The shutter release button activates the
exposure meter when lightly pressed. The
meter Itself stays on for approx. 30 sec.
after you have taken your hnger off the
button.
A Check battery power.
"■ Switch the exposure meter on while
looking through the viewfinder. If one or
two of the red LED exposure indicator
lamps inside lights up, this would mean
normal condition. ’’
Note:
When the shutter speed dial
®
is on B
(bulb), none of the exposure indicator lamps will
light up. Be sure to set the dial at another posi
tion. If none of the exposure Indicator lamps
light up, either the battery is improperly In
stalled—In
which
case
you
should
install
It
properly—or
battery
power
Is
not
sufficient,
in which case you should change the battery.